Fahrzeug Exklusiv Hohe Gaszug Kit [EVO]

Attention is required because Axel becomes heavy abnormally when installing the angle of AxelThrottle by mistake. If attached correctly the effect after installation is the best ~. Repeatedly, attention to too much opening Axel ♪

Purchase for YZF-R25.

■ Installation difficulty
Since the structure of R25 is simple, it is easy to pass Throttle Wire.
"Body installation itself" Easy, but the instruction manual is inadequate. I did not quite understand the installation on the Throttle body side.

■ Notes
It is not due to the product, but the R25 Wire exchange is really troublesome.
Moreover, Throttle Wire is stopped on the way Band (Body fixed) Because it is in a narrow place, it is very difficult to remove. Are you clumsy for me?

Besides Hexagonal Wrench for exterior removal of Body, I think that there is a long Radio pliers and Nipper whose tip is bent.

■ About the product
Quality is good. I used 46, but I felt a little Throttle became heavy.
However, I feel that Axel opening has decreased and driving has become easier.

【Review】
Motorcycle Comprehensive Parts Manufacturer, ACTIVE High Throttle Kit EVO is Throttle holderThrottle Wire - Quantity : Pair (for Left and Right) Gripetc. , The set is set.

Since it is a Kit for exclusive use by car model, Wire length and guide angle are Exactly, so there is no additional work and adjustment work, so you can work with nearly Pon attachment.

The attached Grip is slightly shorter than the OEM.

Wire bracket comes with two types of φ50 and φ52, you can choose according to your preference. The Throttle holder of this size becomes Large type and it can correspond to the maximum Large φ 54. NORMAL's Bracket is φ36. 5, so it will be pretty high Solo. If you want to make it a little more mild High Solo, there are Kit of φ40 and φ42 of different model numbers, but the Throttle holder becomes Small Type and it corresponds to the largest Large φ44.

Since the Throttle opening degree of Z250 is NORMAL and it is 80 degrees, there is something tough if it does not change for full throttle. In this case, since φ 52 was selected, the throttle opening degree became 56 degrees, and it was fully opened without losing its posture without changing at full opening.

[Content points]
Material : Aluminum's Throttle holder is thin and bulky and firmly fastened to Handlebar. Since Holder divides into two, Maintenance can be easily done.

[Unhappy point]
Throttle holder could choose between Silver and Black, but the guide part of Wire is only Silver, so I wish I could choose Black if possible.

I could not do wide opening of Throttle because my hand was small, but it became easier to open it with this.
Circuit I think that it is better to put on if you run.
Motorcycle's Response got better.
Naturally, the operation at low speed will be delicate.
However, it was troublesome to install, as it was 10R it was a little troublesome to remove the Tank for Wire exchange or to change the Throttle Wire's clasp gold fixture.

As a Title, since it is the design only for a vehicle type, attachment is really easy.The circumference of the
Throttle is also the result which seems to be pure.
-- although the Maintenance and

we Bracket also with easy part exchange used phi 42 attached again -- a Throttle work --
-- without becoming a severe to there, since full admission became easy, it is dramatically satisfied.