Replacement M10 Aluminium Sealing Washer for SP Takegawa Equipped Grom
About quality and texture: I am happy with the quality of the sealing washer from SP Takegawa, the washer is made from aluminium and for the M10 sized bolt that are used for blocking oil passages on the SP Takegawa clutch cover and cylinder.About the feeling of use: Previously the oil cooler was connected to the Grom via the cylinder but now with the purchase of a upgraded clutch cover those oil passages on the cylinder needed to be blocked off and the banjo bolts connected to the clutch cover, these washers have sealed these new connections with zero oil leaks showing.Products to buy together: Some M10 oil plug bolts or banjo bolts would also be needed to purchase along side the sealing washers for these new connections to take place.Difficulty of installation: The process to install takes about 5 minutes, give the mating surface a clean, fit a single sealing washer to a oil plug bolt and two sealing washers to a banjo bolt and tighten bolt down to 15N . m. Not difficult to do.Cost performance and comparison with other products: Costing is good as you are receiving a packet of ten sealing washers which works out to be 60 cents each which is much cheaper when compared to the 10 pack available from K-Con.About shipping and packaging: Sea frieght was my perferred method of shipping due to the lower cost but currently unavailable due to Japan Post. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged.Any concerns, cautions, or advice when purchasing: These sealing washers are a consumable item and you need to have spares on hand when carrying out your own maintenance as they tend to leak after being re-used a few times.
Detail anzeigen
