Sie greifen anscheinend aus Europa zu.
Möchten Sie bei webike.eu.com?
253 Bewertungen Art anzeigen:
가격대비 훌륭한 스탠드입니다.
프론트 스탠드를 처음 사용해보는데. 사용법이 어렵지 않았습니다.
바이크에 맞는 어댑터를 앞쪽 고리에 넣은후 바이크에 걸고 들어올리면 됩니다.
상당히 견고하고 바이크를 잘 지지해줍니다.
다만 사용시 앞 휀더에 스크래치가 생기지 않도록 주의를 해야겠습니다.
gsx r1000 에 사용했는데 사용하는데 문제는 없었습니다....Weiterlesen- Tried it on a 2006 cbr600rr.
There's no interference with the cowl, but you can't mount it the way you want unless you remove the horn.
It interferes with wheel extraction, but try adjusting the heigh...Weiterlesen - I purchased this product for MotorcycleMaintenance Nans.I've also purchased for Rear before and found it to be of good quality and easy to use.We chose the sameSeries.There is no problem with the qual...Weiterlesen
- Frontständer20Durch J TripI used it on the front stand of a certain cheap product, but ZEPHYR1100 was too heavy for it, but the J-TRIP product has a multistage height adjustment system that allows for free height adjustment. H...Weiterlesen
- fits:
- HONDA GROM 13-24
- HONDA HRC GROM 13-
[How is it used?CircuitWas the one you received as per Image?Street ImageHow was your experience with it?It is easy to raise by the principle of lever, and I think even women can raise it. These produ...Weiterlesen - I use it on my Z125 and Ninja 650.The Stem that fits both comes from the beginning.There is no need to buy a special Stem for Mini bike separately for about 5,000 yen, like some domestic products.The ...Weiterlesen
- Be careful when the bottom of the Cowl lifts the SS system! It will hit the bottom of the cowl just before it goes up. It is difficult to stop because it is just before it goes up, and a large motorcy...Weiterlesen
- Frontständer20Durch J TripI'm a DAEG rider. 。 There is no problem in using it, but the Horn is in the way as a lifting place, or it is not usable because of the Horn. 。 I had to install it next to the Radiator and even Horn it...Weiterlesen
- Mini FrontständerDurch J TripI used it in NSF100.It is useful when performing maintenance such as wrapping the Warmer around the Front or removing the Fork.It has about 3 Piece and can be used for various vehicles.The quality of ...Weiterlesen
- I bought it to use on my DL1000 V-STROM1000, the Tire floated when fully extended, if it can be used on a V-Strom, I think it can be used on most Motorcycles, it is well made and strong.Weiterlesen
- Gabel aufstehenDurch J Tripfits:
- HONDA DAX125
- HONDA glom
- HONDA MONKEY125
- KAWASAKI Z125
- Others Front 16-21 inches
- ...und mehr.
I had a front stand, but I found this product which is easy to insert into the hole at the bottom of the front CB400T and lift it up, and bought it immediately. The Rear stand is also made by the same...Weiterlesen - Front-up-StänderDurch ETHOSThe construction is solid and easy to use.Most car models will probably go up with this.Storage space is required, so if you have an available Space, it is useful to have it.Weiterlesen
- Vorderer StänderDurch J TripPlease tell us how you are using it.Used for maintenance around FrontWas the one you received as per Image?YesHow was your experience with it?neither good nor bad[Points to note]How did it compare to ...Weiterlesen
- Frontständer20Durch J TripI use it on my current model z1000.Because it rides on the bracket that holds the brake hose in place.I scraped a little with a sander.The product is easy to lift up and is useful for maintenance.Weiterlesen
- I can't replace the tire because the axle shaft is stuck in the front up position. If you want to remove the wheel on CB1000R, please use another company.Weiterlesen
- Front-up-StänderDurch ETHOSI purchased this product because it can be used with the WheelClamp made by the same company, but the axle of the front stand interferes with the clamp and it cannot be used together.However, the fron...Weiterlesen
- I wondered if it would really work, but then I tried it. It worked (laughs).However, I was trying to pull out the Axle Shaft on the front, but depending on the position, the STAND interfered with it a...Weiterlesen
- I used it on my GSX-R125, and although the OEM cowl slightly hits the standdbody, I was able to use it. multiple attachments are included, and I think the cost is good.Weiterlesen
- fits:
- HONDA GROM 13-24
- HONDA HRC GROM 13-
I have been using JTrip's STAND before and after for my 3.5 liter class, 250 class and NSF. It is very light due to the material. It also does not take up much space in the Transporter. However, I can...Weiterlesen
? 
DER GRÖSSTE
SHOP IN JAPAN
EXKLUSIVE GUTSCHEINE,
SALE, DEALS
SCHNELLER, ZUVERLÄSSIGER
Versand