Lenkerabdeckung # 20

I bought it with a bad guy by listening to Handlebar Cover which can be worn with the rumor of the wind with the Handforbar Guard of Offfor Vehicle attached.

I first attempted to install Handlebar Cover with Armor Handguard Straight and XC - PROProtector attached to Zeta, but XC - PROProtector could not fit in Handlebar Cover because of its wide upper and lower width.

So I used the Small Type Protector (Blue color object) After exchanging it and trying again, I managed to install Handlebar Cover.

As for the order of installation, cover Handlebar Cover with Protector removed from Hand guard, then insert Protector from Handlebar Cover hole, install Handlebar Cover slightly and secure Protector to Hand guard Screw fixed.

Handlebar Cover comes with 4 Strings for fixing, of which Quantity : 2pc was too long, so I used the appropriate String on hand.

The bottom side of the Handlebar Cover has a long slit from which the wind invades, so I stuck the Black Gum Tape and closed it. Also, because there are some gaps on the upper side, I closed it with Black Gum Tape.

Cover of Jersey fabric is attached to the insertion mouth of the hand, and it is difficult to enter drafts.

As a feeling of use, even in Gloves for winter with Protector attached to the back of the hand, Handlebar Cover's insertion and removal of the mouth did not have resistance. Handlebar Cover has Hand guard and Protector built in, so there is space to be relaxed, there is no hindrance to Lever operation at all. As a disadvantage, Blinker switch and Engine Starter Motor are hard to operate, but I think this is a problem of Level that can be overcome if you get used to it.

As windbreak protection effect, if we have Gloves for winter, we do not need any further windproof anti-cold measures Level. I think that Cost performance is quite high, texture is suitable for price. Vinyl leather on the outer skin and a thin SpongeMaterial stuck on the whole interior.

Because the price is cheap, I think that there is enough value to try using the original bad.

Although the handle cover of the type which inserts only the handle and lever for mini bikes until now has been used, probably because it became considerably old, the outside of the thumb and an index finger has come to feel it cold from the air infiltration from the insertion hole of a grip.
Only a grip part was not inserted this time but it was made the type entirely covered to a switch part.
Although it was switch operation over a cover until now, since the whole is covered, this product can be operated within a cover, and it becomes quite easy to carry out operation.
Moreover, since it became operation with fingertip feeling since the switch part was not transparent, but this product did not almost have operating it, looking at even if there is no cover, there was no problem in particular.
Since a catalogue is a soft raw material in practice, it does not become the obstacle of handle operation, as appearance and a raw material are changed.
the slit part by which a cover upper mirror passes along the point with regrettable one should pile up -- although it has come to be alike, a lower slit part piles up and is not carried out -- since for the reason the crevice opened at the time of attachment and cold invaded, the measure against a crevice was required.
Since appearance is a form of the handle cover from ancient times, it is not recommended to those who care about appearance, but protection-against-the-cold nature and operativity are the products which we can recommend to you.