I received my Daytona Multi Wing Carrier and, as stated in the listing, the installation instructions were in Japanese. Needless to say neither Bing nor Google Translate were very much help. Through other means I was finally able to fully translate them to English but they were inadequate. Here are my own set of instructions which I used to install the carrier on my 2016 Honda NC700X:The carrier rack's mounting rails are intended to be installed beneath bikes the current grab rails using the included longer screws.1. Open passenger seat.2. Remove main seat by removing bolts and washers (2pc) and set everything aside.3. Remove passenger seat hinge at the top by taking out retaining pin (be careful not to lose washer), then take off washer and set both aside.4. Remove grab rail bolt caps (take care not to lose them as they pop off) and set aside.5. Loosen grab rail bolts. (2pc per side)6. Attach half of included foam tape to each carrier rail along front edge of curved carrier arm mount point on the bottom side. (The point where the carrier plate meets the rails is considered the back and top fo the mounting rail.) 7. Remove the grab rails and set the bolts and washers aside.8. Loosely re-install the grab rails with corresponding carrier rail beneath them using the included long bolts and old washers. (Be careful while positioning them around the plastic fairing.)9. Loosely attach carrier plate to carrier rails using included bolts and nuts.10. Tighten grab rail bolts and carrier plate bolts.11. Replace grab rail bolt caps.12. Re-attach original seat using original bolts and washers.13. Re-attach passenger seat hinge by putting back washer and retaining pin.14. Close passenger seat.Hope this helps someone, who was as lost as I was, get their carrier installed.
Detail anzeigen Sie greifen anscheinend aus Europa zu.
Möchten Sie bei webike.eu.com?
