Blinker

Passt:HONDA LITTLE CUB (Rear)

Pavel Rastrygin

Sehr gut

May 3, 2023

MADMAX Блинкер

Приобретал для Honda Little Cub. По качеству изготовления есть вопросы, короткие провода. Не понравилась внутренняя конструкция. В конечном итоге собрал что-то среднее из старого комплекта и нового. При невозможности приобрести оригинальные повороты, брать можно, цена адекватная.Purchased for Honda Little Cub. There are questions about the quality of workmanship, short wires. Didn't like the interior design. In the end, I assembled something in between the old kit and the new one. If it is impossible to purchase original turns, you can take it, the price is adequate.

Hilfreich?

Passt:HONDA LITTLE CUB (Rear)

Japanese Webike user

Schlecht

Nov 6, 2021

Plating is Beauty

Was the one you received as per Image?
It's almost exactly as Image, but the base is cheaply made.

[Points to note]
You need to pay attention to the Wiring, and it doesn't work according to the Instruction Manual. Both the wiring of the single car and the wire of this product must be cut and connected.
The pedestal has rusted within 6 months.

Hilfreich?

It's good for cheap if you think of it as repair Parts

Passt:HONDA LITTLE CUB (Rear)

Japan User(translated)

Sehr gut

Jun 27, 2019

It's an OEM shape and it doesn't look like an Other Brand Product, but Since the lens is not screwed on but fitted, it is not the same as other manufacturer's Clear Lens etc. cannot be installed
Also, for some reason, Wiring's handling is from a different place than the OEM, so I'm going to have to change the Base part once I had to take it off and put it back on
The price is low and it's a good repair part

It's good for cheap if you think of it as repair P...

Hilfreich?

Passt:KAWASAKI Z1 , KAWASAKI Z2 (750RS/Z750FOUR) Conformity and other information]Old

Japanese Webike user

Sehr gut

Jan 27, 2021

ZBlinker

I received the product today.
There is no problem with the appearance, but there is a BALI left when the bolt hole was machined for fixing inside the Blinker Bracket, and it is necessary to remove the BALI.
The inside of the blinker looks fine, but the packing inside the lens is not rubber, but SpongeMaterial-like packing, so I think it lacks waterproofness, but considering the cost performance, I think it can be recommended. I think it is a product that can be done.

Hilfreich?

Passt:KAWASAKI Z1 , KAWASAKI Z2 (750RS/Z750FOUR) Conformity and other information]Old

Japan User(translated)

Ausgezeichnet

May 28, 2015

It is good making.

I attached it to the vehicle during Restore. Appearance is almost the same as OEM. Plating's texture is also good so I think that here is enough even if OEM is not available.