Achse Adaputer für GROM

Da bei meinem Motorrad ab ca. 85 km/h die Wellendichtringe angefangen haben zu pfeiffen musste ich die Braue, welche eigentlich das montieren vereinfachen sollte, auf der Drehbank entfernen.Das Problem hatte ich jeweils auf der Vorderachse bei einer Honda Monkey und einer Honda MSX / Grom.

Grom JC75
I installed it while I was replacing the shaft.
I'm happy with my dress-up.
If you're not a Red type, it might be a little flashy.

The OEMs are falling all over themselves to...
This product makes it much harder to fall off and is much less frustrating! (?´ω`?)

I bought Red and I really like it because it's a nice Accent and I wish I could have been there. (*´з｀*) no
(Gold would have been even better...)

You should replace it when you think about the OEM Colors that fall out of polo.
Because the painting of the color was shaved off, I bought it again because the squeak sound occurred because I inserted it into the Dust Seal at an angle just a little bit, and the paint of the color was shaved off.

What made you decide to buy?
KITACO:Change from Axle Color to G-Craft:Change to Axle Color for GROM KITACO:Axle Color is also the Parts that I installed after purchasing a new car I have been using it for about three years, but recently, the corrosion of Aluminum peculiar to Aluminum has come out I changed it because of this

How was your experience with it?
KITACO：AXIS Luchre is also Material:AluminumCut-outAnodized Finishing is lightweight However, G-Craft:Axle Color for GROM is also made by Duralumin It's Anodized Finishing and lightweight What I felt was that the G-Craft felt lighter than the KITACO Does that difference translate into a ride? The question is subtle

Was the installation difficult?
To change the Axle Color on the rear, you can use the Racing Stand to change You can do it Smoothly However, the Front is a bit tricky. if you have a STAND for Front, you can replace it with It can be done easily, but I think that there are few people who have the Front stand In that case, you can work easily if you put the rope on the Handlebar and lift it up.. This is an effective method of working if you have a place to lift it Or, I think it would be a good idea to request installation at the same time as the Tire replacement

What is the point or hang of the installation?
I'm frustrated with the dropouts during Axle Color installation Probably, the Axle Color dropout has been experienced by those who have replaced it, but the G-Craft product The edge of the collar has a ribbed edge and is designed to catch on the Rip portion of the Dust Seal The serviceability is a little better than OEM and other companies' products However, it does not mean that the Axle Color will not fall off perfectly, so please work with caution I put Cushion under the Axle Color to prevent scratches from falling off By the way, the Axle Color on the rear side has a quantity:Pair (for Left and Right) Please note that there is a specification of

Do you have any wishes or suggestions for the Manufacturer?
I think the accuracy of G-Craft products is the best Please sell various products for the MINI lover in the world in the future I'm looking forward to it

[Do you have any products to compare it to?
It is KITACO:AXIS LUCALAR, which I used before Both companies are good products I recommend both of them because they are both products that show corporate efforts