Griffheizung GH05-2 Wicklung

This winter, the temperature has been below 0 degrees Celsius, and I couldn't stand the coldness of Lever even though I commute only 6 km, so I decided to buy it.
The GripType was also attractive, but if it could not be used, it was also a reasonably priced winding type. (95mm) to

I think that it is the range which can endure if I think that the period of use is about three months though there is an uncomfortable feeling in it because Grip becomes thicker for the amount rolled up.


There was some concern that the battery capacity might be insufficient for the Z125pro, but when I installed it, the engine started and I was able to use it.
Even if it is only the palm side of the hand, it warms up and the hand becomes very easy.
However, just in case, I try to charge the Battery on holidays.

It gets very hot when I install it and switch on the Engine. Especially the right hand side gets hot.
I switched the order of connection to be sure, but it's the same.
Quantity:Pair (for Left and Right) The difference could possibly be a matter of Battery capacity.

The power supply is KITACO's "Power Extraction Harness. was used.
Plus side (I bought the Bullet Type Terminal at Homsens.) The Minus side is tightened to the screw of the Side cowl under the Seat.

It is also a note in the product description. "125cc and below... So, it is your own responsibility when you install it.

As for the installation, it is also uploaded to the diary.

Installed on 125Scooter for commuting.
The temperature is quite warm. It becomes about a hot drink of a vending machine.
I think it is necessary to use it together with the Handlebar Cover, but I am sure that you will want to touch it even when you are stopped.
Quantity:Pair (for Left and Right) Because the Wiring of the part which branches to Seat of the "Mere Old Man" is bare, I am worried whether it will not be cut.
It's a thin line, so I wanted it to be well protected.

I installed it on a CYGNUS X-SE44J. Grip replacement type and this one is from the old days I bought the winding type because And the Grip itself does not become thicker, so you can use all Season comfortably But if you use the winding type, you can run the Season in your favorite Grips when you are not using it Winding type is also available I can ride it for 5 minutes, but I can get used to it and it's not a problem
The handling instruction manual is also available and the length of the Harness is sufficient Also, the Switch is not a volume type, it is only on/off, but I don't care about it at all It is not

I purchased this item that I can remove because it is used only in winter. About installation and Wiring, there is nothing difficult if you do while watching instruction manuals and photos. Power took Plus from Horn and Earth tightened to Ool cooler's Bolt. We bundled Wiring somewhat and pushed it behind Headlight after applying Waterproof treatment. Switch fixed Double-sided Tape to Left Handlebar Switch. I fix it with String to fix Heater, but I will unwind and loosen, so I would like you to improve here. I fixed it with Tie Wrap. Engine on Switch-on and tried it immediately. First of all, when you grasp it before running it is warm enough to touch with bare hands. And while I tried running on an ordinary road and an expressway in a temperature of 4 degrees, on a general road it was warm enough and comfortable even from above Gloves. On the expressway, the speed increased and the hit of the running wind became stronger, so it was not able to keep as much as the general road, but the warmth was felt. However, since the fingertips could not be completely warmed in any case, Handlebar Coveretc. I think whether you can run comfortably if used together. Cospa is also good, installation is easy and comparable, so I think that it is worth a try. I was good to purchase myself..

Easy to install, even warm Warm Gloves thick. (Thumb only does not warm up)
The thickness of the Heater and the thickness of the Gloves somewhat decrease operability, but it is satisfactory given the price.