This screw located near intake valve cover of the cylinder head on my 1987 TW200 . what is so special about this bolt ? It is the cylinder head bleeder bolt. After an oil change and as soon as start the engine you should loose this bolt open about a half to three quarters turn and should see oil seep out telling you the oil is flowing to the head from the lower crankcase .When You change your engine oil don't forget to put correct oil filter ,It has four tiny hole that goes into the engine. Never, ever change the filter without bleeding the line up top because while the filter cap and filter are off the line could drain and leave an air block which could blow the top end of your motor. want to make sure this bolt torqued properly after the bleed check.THANKS A LOT WEBIKE FOR THE SUPPORT.
Detail anzeigen Sie greifen anscheinend aus Europa zu.
Möchten Sie bei webike.eu.com?
